|
AMT3000 Specifications
|
|
Frequency Coverage:
|
530
kHz - 1700 kHz in 10 kHz steps or 522 kHz - 1710 kHz in 9 kHz steps,
depending on order option
|
|
Frequency Selection Method:
|
8-position
DIP switch
|
|
Frequency Tolerance @ 25ºC:
|
±.003%
|
|
Modulation Type:
|
Amplitude
Modulation (AM)
|
|
Maximum Modulation Level:
|
100%
|
|
Power Input to Final RF
Stage:
|
100
mW
|
|
Antenna:
|
118”
wire (supplied with kit)
|
|
Antenna Matching:
|
Tunable
pi-network. Matches high impedance
antenna to low-impedance RF output
stage.
|
|
Output Tuning:
|
4-position
DIP switch selects inductance combination, adjustable ceramic trimmer
capacitor peaks resonance.
|
|
RF Output Metering:
|
Test
points on circuit board provide DC voltage to user-supplied 10 megohm/volt
voltmeter. Measured voltage is
maximum at resonance.
|
|
RF Grounding Options:
|
Jumper
plug options for including/excluding RF isolation inductors in power supply
and audio source ground paths.
|
|
Audio Response:
|
20
Hz to 20 kHz ±1 dB
|
|
Audio Treble Boost:
|
+8
dB, boost midpoint at 2 kHz. Jumper
plug option.
|
|
Audio Distortion:
|
Less
than 0.5% THD through audio stages.
|
|
Minimum Audio Input Level:
|
200
mV RMS for 100% modulation (input gain control at max).
|
|
Audio Compression:
|
Compression
ratio adjustable from 1:1 to 5:1.
Attack time less than 1 ms.
Medium release time suitable for both voice and music.
|
|
Audio Limiting:
|
Adjustable
threshold. 15:1 compression above
threshold.
|
|
Front Panel Controls:
|
Audio
input gain, modulation level, compression ratio.
|
|
Rear Panel Jacks:
|
2
RCA audio in jacks, RCA antenna/ground jack, 2.1 mm power input jack.
|
|
Power Consumption:
|
120
VAC, 2 watts
|
|
Circuit Board:
|
5”W
x 3.9”D x .062”H FR4, two layers, 1 oz. copper, top and bottom solder
masks, top silkscreen.
|
|
Enclosure:
|
6.1”W
x 4.2”D x 1.5”H ABS plastic.
Drilled and labeled front and rear panels.
|
